Emerson Rosemount 56 - Page 46

Section 4: Display and Operation Instruction Manual
April 2017 LIQ-MAN-56
36 Display and Operation
transfer is done by using a version 2.0 USB flash drive (USB memory stick) for downloading
the existing configuration and uploading to another instrument.
4.8.2 Transfer Configuration Process User Notes
1. Configuration Transfer can only be performed between instruments of identical configu-
ration. The analyzers must have the same signal boards installed.
2. Several text files downloaded to the flash drive can be saved to a PC and used later.
3. Only one set of configuration files will be stored on the flash drive. The files that are
downloaded will over-write any existing files stored in the root directory of the flash
drive.
4.8.3 Transfer Configuration Procedure - User Notes
1. Confirm all user settings before transferring configuration.
2. From the main menu, select Data storage and retrieval.
3. Select the Transfer Configuration tab
4. Select “Copy analyzer configuration to the flash drive”.
5. With the 56 analyzer powered, remove the NEMA cap from the front display by inserting
a coin into the cap’s vertical slot and rotating counterclockwise. Remove the USB cap to
access the data port.
6. Carefully insert a USB 2.0 flash drive into the USB port on the 56. Note that the USB inser-
tion connector is keyed.
7. Select Copy data. Press ENTER.
8. An information screen appears warning users that any configuration files that exist in the
root directly of the flash drive will be over-written upon configuration transfer. If No is se-
lected (default setting), existing configuration files will not be overwritten. Select Yes to
transfer the configuration file to the flash drive.
9. The configuration file will be transferred (downloaded) in about 20 seconds. A screen
will report that the configuration file has been transfused.
10. Carefully remove the USB 2.0 flash drive from the USB port.
11. Insert the NEMA cap into the 56 USB front display opening.
12. Follow steps 2-3 above on the instrument that will receive the copied configuration.
13. On the 56 analyzer instrument that will receive the copied configuration, remove the
Type 4 cap from the front display.
14. Carefully insert the USB 2.0 flash drive containing the configuration file into the USB
port.
15. Select “Copy configuration from the flash drive to the analyzer”. Press ENTER.
16. You have two options for configuration transfer. Select one of the following and press
ENTER:
a. Copy configuration data only to the analyzer.
b. Copy configuration and calibration data to the analyzer.
17. Select Copy data. Press ENTER.
18. The configuration file will be transferred (uploaded) in about 20 seconds. A screen will
report that the configuration file has been transfused.
19. Carefully remove the USB 2.0 flash drive from the USB port.
20. Insert the NEMA cap into the 56 USB front display opening.