P. Heater strut assembly
Procedure
1. Before installing sample block heater rods (E, Figure 9-20), evenly coat the heater
rods with Watlube heater release agent.
2. If thermal switch (K) was removed, install thermal switch on mating heater clamp
(L), connect wires of heater rods (E), and install insulator (I).
3. Install the heater rods (E), heater clamps (L), and screws (N).
4. Reconnect the heater rod leads at the housing terminal blocks (Figure 9-21).
Maintenance and service
Reference Manual 245
To Next Page
Loading...
