Emerson Rosemount OCX 8800 - Jumper and Switch Settings

B.4.1 Jumper and switch settings
If the SPA with HART was factory-configured by Emerson for operation with your
transmitter, jumper and switch setting adjustments are not required. However, you may
use the following procedure to verify that the jumper and switch settings are correct.
Adjust or verify jumper and switch settings as follows:
SPA jumper and switch settings are shown in Figure B-3.
CAUTION!
EQUIPMENT DAMAGE
Protect the SPA from electrostatic discharge (ESD) to avoid damage to the SPA electronic
circuits.
Procedure
1. Refer to Figure B-3. Turn the SPA over and slide the access cover out.
Before changing any jumper or switch positions, take adequate precautions to avoid
an electrostatic discharge.
SPA jumper and Dip switch settingsFigure B-3:
SPA with HART Alarm
278 OCX 8800