CAUTION!
EQUIPMENT DAMAGE
Do not allow the temperature of the electronics housing to exceed 185 °F (85 °C) or
damage to the electronics may result.
CAUTION!
EQUIPMENT DAMAGE
Whenever a positive stack pressure exists at the installation site, be sure to connect all
pneumatic lines prior to installing the OCX 8800 in the stack or ductwork. Failure to
connect the pneumatic lines can allow the flow of contaminants into the OCX 8800
ports.
2.2.2 Installation
Follow the procedure below to install the OCX 8800 in a flue or stack.
The OCX 8800 may be installed intact as it is received.
Prerequisites
Ensure all components are available to install the OCX 8800.
Procedure
1. Weld or bolt the adapter plate (Figure 2-1) onto the duct.
Install
Reference Manual 21
To Next Page
Loading...
