Adapter Plate InstallationFigure 2-1:
E. Masonry stack wall
F. Field weld pipe to adapter plate
G. Pipe 3 inch schedule 40. Sleeve length optional.
H. Bolt adapter plate to outside wall surface. Joint must be air-tight.
I. Metal stack or duct wall
J. Weld or bold adapter plate to metal wall. Joint must be air-tight.
Note
Dimensions are in inches with millimeters in parentheses. Only adapter plate is furnished by
Emerson.
Adapter Plate Kit Mounting DimensionsTable 2-1:
Type part number
(1)
Plate size A Sutd size B Bolt circle dia. C
ANSI (P/N
4512C34G01)
6.00 (152) 5/8 - 11 UNC - 2A 4.75 (121)
DIN (P/N
4512C36G01)
7.50 (191) M - 16 x 2.0 - 6g 5.71 (145)
(1) Part numbers for adapter plates include attaching hardware.
2. Ensure the conduits drop vertically from the OCX 8800 and the conduit is routed
below the level of the conduit ports on the housing to form a drip loop.
Drip loops minimize the possiblity that moisture will damage the electronics
(Figure 2-2).
Install
22 OCX 8800
To Next Page
Loading...
