a. Press SELECT.
Observe the display window on the SPA front panel. The display window should
read SET HART.
See the SET HART command in Figure B-6. The SET HART submenu and related
parameter values that must be selected via the front panel buttons on the SPA
are to the right of the command window.
In the submenu views shown:
means press down.
means press up.
means press SELECT one time.
means press or until the desired parameter value is shown in the SPA window.
b. Proceed through the SPA menu, selecting the menu commands and parameter
values as indicated.
c. After completing the sequence in the first column, go to the top of the second
column and continue.
d. To exit the menu, repeatedly press SELECT to display any main menu command.
Then press or until CONF EXIT is displayed. Select CONF EXIT.
The SPA user manual provides detailed instructions concerning the configuration
menu and the submenu structure for each main command.
SPA with HART Alarm
Reference Manual 283
To Next Page
Loading...
