S4K2UC SERIES USER MANUAL | 31
5.0 Communication
This section describes UPS communication over the three types of communication connections on the rear of the S4K2UC:
• IntelliSlot port
• USB port (standard B-type)
• Terminal block communication
!
CAUTION
To maintain safety (SELV) barriers and for electromagnetic compatibility, signal cables should be segregated and run
separately from all other power cables.
5.1 IntelliSlot Communication Cards
The IntelliSlot port accepts two optional cards:
• SNMPWEB Card. The IntelliSlot SNMPWEB Card provides SNMP monitoring and control of the UPS across the
network.
• IS-RELAY. The IntelliSlot IS-Relay Card provides dry contact relay outputs for custom-wired applications and delivers
support for built-in shutdown for AS/400 systems.
Follow the instructions provided with the IntelliSlot card to congure MultiLink, the UPS, or any additional ancillary
product for the S4K2UC. These instructions are also available at: www.solahd.com.
5.1.1 MultiLink
MultiLink monitors the UPS continuously and can shut down your computer or server in the event of an extended power
failure. MultiLink can be congured to shut down the UPS as well.
MultiLink can also be congured for use without the USB cable when the IntelliSlot SNMPWEB Card is installed in the UPS.
An optional MultiLink license kit allows you to shut down the UPS over a network. For more information about the Multi-
Link license kits, visit our Web site (www.solahd.com) or contact your SolaHD representative.
5.2 USB Port Communication
The standard B-type USB port is used to connect the UPS and network server or other computer system using MultiLink.
The conguration program can be completed through the communication port.
To Next Page
Loading...
Need help?
General