Emerson SP3403 - Footprint Mounting the EMC Filter; Bookcase Mounting the EMC Filter; Size 4 to 6 Mounting of EMC Filter; Mounting the External EMC Filter

Safety
Information
Introduction
Product
information
System
design
Mechanical
installation
Electrical
installation
Getting
started
Optimisation Parameters
Technical
data
Component
sizing
Diagnostics
56 Unidrive SP Regen Installation Guide
www.controltechniques.com Issue Number: 2
The external EMC filters for sizes 1 to 3 can be footprint or bookcase mounted, see Figure 5-17 and Figure 5-18. The external EMC filters for sizes 4
to 6 are designed to be mounted above the drive, as shown in Figure 5-19.
Mount the external EMC filter following the guidelines in section 4.11.5 Compliance with generic emission standards on page 88.
Mount the external EMC filter following the guidelines in section 6.12.5 Compliance with generic emission standards on page 62
Figure 5-21 Size 1 external EMC filter
All filter mounting holes are suitable for M6 fasteners.
Figure 5-17 Footprint mounting the EMC filter Figure 5-18 Bookcase mounting the EMC filter
Figure 5-19 Size 4 to 6 mounting of EMC filter Figure 5-20
Mounting the external EMC filter
DY
Z
V: Ground stud: M5
X: M6 threaded holes for footprint mounting of the drive
Y: Footprint mounting holes 6.5mm (0.256in)
Z: Bookcase mounting holes 6.5mm (0.256in)
∅
∅
L3L1 L2
H
B
A
CW
X
X
Y
Y
Z
Z
V
Cable size:
2.5mm
14AWG
2
CT part no.ManufacturerABCDHW
4200-6118
Schaffner
390 mm
(15.354 in)
423 mm
(16.654 in)
74 mm
(2.913 in)
45 mm
(1.772 in)
440 mm
(17.323 in)
100 mm
(3.937 in)
4200-6119
4200-6121
Epcos
450 mm
(17.717 in)
4200-6120