Need help?Do you have a question about the Emotiva Fusion Flex and is the answer not in the manual?
Controls power state and indicates status (Standby/On/Fault).
Manually select inputs or use Auto mode; LEDs show active input.
Adjust the amplifier's volume level gradually.
Switches the unit between Standby and On modes.
Increase or decrease volume gradually using the control ring.
Manually select inputs (1, 2) or use Auto mode based on active audio signal.
Toggles mute On/Off. Volume LEDs extinguish when muted.
Accepts RS-232 control codes for wired remote control.
Allows trigger-enabled equipment to switch amplifier between On and Standby.
For connecting an external IR sensor if front panel IR is blocked.
How Power Mode switch (On, Auto, Off) affects amplifier operation.
Check power source, switch, and cord connections.
Verify power mode, signals, or faults; reset unit if necessary.
Check input selection, volume, source, cabling, and speaker connections.
Disengage Volume Lockout by holding the front panel Input 1 button.
To Next Page
General
