Emotiva Fusion Flex - Performance Specifications

Page 17
Fusion Flex Amplier
Performance Specications
Input sensitivity (for full output):
600 mV.
Auto switch response time:
(On from Standby or switch to priority input on sense); < 10 seconds.
Minimum recommended load impedance:
4 ohms (one 4 ohm load or two paralleled 8 ohm loads per channel).
Power output:
50 watts/channel @ 8 ohms.
75 watts/channel @ 4 ohms.
S/N ratio:
> 95 dB (A-weighted).
Frequency response:
20 Hz to 20 kHz +/- 0.08 dB.
Trigger and control:
Trigger Input: 5 - 20 VAC or VDC.
Serial: Standard RS-232 drive levels.
Protection:
The Fusion Flex Amplier is protected against excessive operating temperature, shorted
speaker connections, ground faults, and other common fault conditions. If a fault occurs,
the Fusion Flex Amp will automatically power down and the front panel Standby LED will ash
red. To reset the protection, turn the Fusion Flex Amp O and then On again using the REAR
PANEL POWER SWITCH after the fault has been removed.