Emotiva Fusion Flex - Operating the Fusion Flex Amplifier; Powering On and Off; Audio Input Selection Process

Page 10
Fusion Flex Amplier
7. RS-232 Serial Remote Control Interface
Accepts RS-232 control codes from a wired serial remote control.
8. Trigger Input
The Trigger Input is used to allow other trigger-enabled equipment to switch the Fusion Flex
Amplier between On and Standby.
9. IR Input.
Connect an external IR sensor to this input if the Fusion Flex Amplier is mounted such that IR
remote control signals cannot reach the front panel directly.
10. Power Mode Switch.
Selects between regular, triggered, and auto-on power modes.
Refer to the Installation Tips and Conguration sections for details.
11. Standard IEC Power Inlet.
The Fusion Flex Amplier requires a standard IEC C7/C8 (2.5A two wire) power cable.