EMS FIRECELL User Manual

Panel Programming
The Radio Hub, RCCs and all wireless devices must now be added to the control panel. Ensure the Loop
number and addresses programmed at the Radio Hub correspond to that programmed at the Control
Panel.
Ensure write switch is set to enable.
Turn the key switch to the enabled position.
Press the button to enter the menu.
Press the button to scroll down the menu until ‘Access Level 3’ is highlighted.
Press the button to enter the menu.
Now to enter the pin number, press the button four times (thus entering 3333).
Press the ‘Enter’ button to enter the pin.
Enter the ‘Edit Cong’ menu with the button.
Press the button to scroll down the menu until ‘Add device’ is highlighted.
Press the button to enter the menu.
Press the & buttons to highlight the desired loop number for the device.
Press the button to select the loop required.
Press the & buttons to scroll through the available address numbers.
Press the button to select the address required.
Press the & buttons to scroll through the device types until the desired device type
is shown.
Press the ‘Enter’ Button to enter. Conrmation of the addition to the system should now be
shown.
Once complete, press the ‘Exit’ button to escape the menu.
2
2
2
2
2
2
1
1
1
3
3
3
3
3
3
Page 10 of 40©2019 EMS Ltd. All rights reserved. MK98 Iss17 05/04/2019 AJM

EMS FIRECELL Specifications

General

Brand	EMS
Model	FIRECELL
Category	Fire Alarms
Language	English