To Next Page

To Previous Page

Page 34 of 40

Start Fast Test; in this menu, loops can be entered into fast test for ease of testing. This allows the

detectors on the selected loops to be triggered into an alarm condition quicker than normal. The led on

the device will ash to indicate it is in this fast test mode. A time period of between 1 and 30 minutes is

selectable which decrements and is then re-generated on a re alarm event. The devices automatically

come out of fast test mode when the timer expires or the fast test mode is exited.

Front Display Advanced Start Fast Test

RCC Comms Path; this menu allows you to view to path of communication between Radio Cluster

Communicator (RCC) to the Radio Hub whether it is direct from the RCC to the Radio Hub or from the

RCC to the Radio hub via another RCC. The loop number and address number is shown along with the

number of hops the RCC uses to communicate to the Hub. Pressing the rotary control with the required

RCC shown will then show the RCC or Hub that particular RCC is communicating to.

Front Display Advanced RCC Comms Path

Chg RCC Comms Path; this menu allows you to change to path of communication between Radio

Cluster Communicator (RCC) to the Radio Hub whether it is direct from the RCC to the Radio Hub or from

the RCC to the Radio Hub via an RCC.

Front Display Advanced Chg RCC Comms Path

Replace RCC; this menu option is not currently used on this version of software.

Sounder Mode; this menu allows the auto silencing of wireless sounders to be programmed. Available

options are Continuous which disables any auto silencing rules and 30 min cut o. The default setting is

to 30 min cut o which will turn all wireless sounders o after 30 minutes to conserve battery life. Any

subsequent re alarm activations will re-activate the sounders again.

Front Display Advanced Sounder Mode

EMS FIRECELL User Manual

Other manuals for EMS FIRECELL