23
Figure 61
Figure 62
Wait until the lock icon switches off. The handpiece
cannot be disconnected when the lock icon is on.
6.2. DISCONNECTING THE HANDPIECE
Make sure that the console is still on during this
procedure.
Make sure that the lock icon is off.
Figure 63
1. Pull back the metallic part of the handpiece connector
to disconnect the handpiece.
Figure 64
If the mechanical disconnection of the handpiece
is not possible when the console is switched off,
refer to the Troubleshooting section.
2. Plug the cap on the handpiece connector in the front
panel.
Figure 65
To Next Page
Loading...
