EMS Swiss LithoCast Trilogy FT-231 - Downloading Logfile; Replacing Fuses

30
SWISS LITHOCLAST BLAST - FB-610/EN 23-JUNE-2017 / EMS CONFIDENTIAL
7. Replace the console on a at surface.
8. Refill the cooling system. Refer to the Filling the
Cooling System section.
8.2. REPLACING FUSES
1. Disconnect the power cord at the rear of the console.
Figure 78
2. Remove the fuse drawer located in the power socket.
Figure 79
3. Replace defective fuses with the fuse type specied
on the identication plate at the rear of the console.
4. Re-insert the fuse drawer.
5. If the fuses fail again, please contact your EMS autho-
rized service center.
8.3. DOWNLOADING LOGFILE
An EMS service center may request this procedure.
1. Plug the USB key provided by EMS at the rear of the
console.
2. From the STANDBY screen, select PARAMETERS
3. Press LOGFILE DOWNLOAD.
4. Follow the procedure displayed on the screen.