5
1. SAFETY PRECAUTIONS
EMS and the distributor of this product accept no liability for direct or consequential injury or damage resulting from
improper use, arising in particular through non-observance of the operating instructions, or improper preparation and
maintenance.
Instructions for use are explicitly given at installation by an EMS representative.
Before using this product, please carefully read,
understand, and follow the recommendations in the
instruction manual. Failure to observe the operating
instructions may result in the patient or user suffering
serious injury or the product being damaged. This
product may only be applied for its intended use
by qualified personnel and for the applications
described in this manual. If the product is used in
combination with other instruments, please refer to
their instruction manual.
Do not use this product in the presence of ammable
anesthetics or oxidizing gases (such as nitrous
oxide (N2O) and oxygen) or in close proximity
to volatile solvents (such as ether or alcohol), as
explosion may occur.
Before using the product, inspect for any damage.
Do not use if the product is damaged. Use original
EMS spare parts and accessories only.
Do not modify or repair the product yourself. Please
contact an EMS authorized service center.
To avoid risk of contamination, before each use,
always clean, disinfect and sterilize the product
according to the EMS reprocessing instructions.
To avoid injury or damage, make sure that the
fragmentation energy is supplied only upon contact
of the probe with the stone. Do not touch the probe
during activation.
When the mains power switch is in the “0” position,
the product is disconnected from the supply network.
Do not tilt or ip the console without rst having
purged the cooling system. Always empty the
cooling circuit before transport. Please refer to
Emptying the Cooling Liquid Circuit section.
Do not start treatment without ensuring that a
back-up probe is available.
Make sure that the handpiece, handpiece fluid
aspiration connector, and re-usable wrenches are
sterilized before proceeding with installation.
Any serious incident that has occurred in relation to
the product should be reported to the manufacturer
and the competent authority.
To Next Page
Loading...
