Endress+Hauser HART Micropilot S FMR533 - Commissioning; Function Check; Switching on the Measuring Device

Commissioning Micropilot S FMR533 4 to 20 mA HART
40 Endress+Hauser
6 Commissioning
6.1 Function check
Make sure that all final checks have been completed before you start up your measuring point:
• Checklist "Post-installation check", → ä 21.
• Checklist "Post-connection check", → ä 27.
6.2 Switching on the measuring device
When the device is switched on for the first time, the following messages appear on the display:
⇒
Select the language
(this message appears the first time the device is switched on)
⇓
Select the basic unit
(this message appears the first time the device is switched on)
⇓
The current measured value is displayed
⇓
After
F
is pressed, you reach the group selection
This selection enables you to perform the basic setup
ENDRESS + HAUSER
E
+
–