Endress+Hauser iTEMP HART TMT162 - Page 24

Commissioning TMT162
24 Endress+Hauser
Sensor
connection
See Function group SENSOR 1 + + V4H1
Cold junction See Function group SENSOR 1 + + V4H2
External
temperature
See Function group SENSOR 1 + + V4H3
2-wire
compensation
See Function group SENSOR 1 + + V4H4
Offset See Function group SENSOR 1 + + V4H5
Measurement
unit
See Function group SENSOR 1 + + V4H6
Serial no.
sensor
See Function group SENSOR 1 + + V4H7
Function group SENSOR 2 (only on a device with 2 sensor inputs)
Available in ReadWin
®
2000, HART
®
handheld module DXR275/375 (Symbol
7
),
Commuwin II with Matrix address
ReadWin
®
2000
7
/FieldCare CW II-
Matrix
Function group OUTPUT
Available in ReadWin
®
2000, HART
®
handheld module DXR275/375 (Symbol
7
),
Commuwin II with Matrix address
ReadWin
®
2000
7
/FieldCare CW II-
Matrix
PV lower range
value
Input of 4 mA value.
Input: Limitation values see device function SENSOR TYPE 1/2.
32 °F (0 °C)
++V1H4
PV upper
range value
Input of 20 mA value.
Input: Limitation values see device function SENSOR TYPE 1/2.
212 °F (100 °C)
++V1H5
Analog output Input of the standard (4 to 20 mA) or inverse (20 to 4 mA) current output signal.
Input:
• 4 to 20 mA
• 20 to 4 mA
++V1H6
Filter Selection of the digital filter 1. order (filter time constant).
Input: 0 to 60 s
++V1H7
HART Output/
Multidrop
Preamble Input: Number of response preambles: 0 to 15
5
-+HART
Server
Device
address
Input: HART address of the temperature transmitters:
0 to 15
!
Note!
If addresses > 0, the temperature transmitter
is in Multidrop mode and the analog output is set to 4 mA. Device
address is shown on the display in the Multidrop mode