Endress+Hauser iTEMP TMT71 - Page 14

Installation iTEMP TMT71, TMT72
14 Endress+Hauser
4.2.1 Mounting the head transmitter
1
2
3
4
5
6
7
9
8
1 2 3 4 5
1
2
3
4
120 mm
(4.72 in)
120 mm
(4.72 in)
Item A
Item B
Item C
A0039675-EN
 4 Head transmitter mounting (three versions)
Procedure for mounting in a terminal head, Fig. A:
1. Open the terminal head cover (8) on the terminal head.
2. Guide the connection wires (4) of the insert (3) through the center hole in the head
transmitter (5).
3. Fit the mounting springs (6) on the mounting screws (7).
4. Guide the mounting screws (7) through the side boreholes of the head transmitter and
the insert (3). Then fix both mounting screws with the snap rings (2).
5. Then tighten the head transmitter (5) along with the insert (3) in the terminal head.
6. After wiring→  18, close the terminal head cover (8) tightly again.