Commissioning iTEMP TMT71, TMT72
30 Endress+Hauser
7.2 Switching on the transmitter
Once you have completed the post-connection checks, switch on the supply voltage. The
transmitter performs a number of internal test functions after power-up. During this process,
a sequence containing device information appears on the display.
The device operates in normal mode after approx. 7 seconds, including the attached display.
Normal measuring mode commences as soon as the switch-on procedure is completed.
Measured values and status values appear on the display.
If the display is attached when the Bluetooth interface is activated, display initialization
is performed twice and Bluetooth communication is disabled simultaneously.
To Next Page
Loading...
