Endress+Hauser Liquicap T FMI21 - Mechanical Construction; Design, Dimensions; Probe Shortening Set

Liquicap T FMI21
10 Endress+Hauser
Mechanical construction
!
Note!
All dimensions in mm (100 mm = 3.94 in)
Design, dimensions Rod probe
Process connection with parallel thread G 1½ or with tapered thread NPT 1½.
L00-FMI21xxx-06-05-xx-en-000
* Ground rod (uninsulated)
** Probe rod insulated
Probe shortening set
L00-FMI21xxxx-17-06-xx-en-000
!
Note!
If shortening the probe rods, the insulation above the cut must not be damaged!
Recalibration is always necessary after shortening the probe. The active rod probe begins above the probe
shortening set. Therefore the zero balance should be carried out at this place. Only the insulated rod must be
insulated with the shortening set. The ground rod remains uninsulated.
max. 76
ø85
ø4
145
22
37
G1½
ø5
23.5
38.5
NPT 1½
max. 76
ø85
164
***
ø4
ø5
***
Probe length L
150…2500 mm
Probe length L
150…2500 mm
AF 55AF 55
Cover
Housing
Process connection
Adapter
Eye screw
Sealing ring
Insulating cap