Endress+Hauser Liquiline CM44P - Page 19

Liquiline CM44P Mounting
Endress+Hauser 19
3. Slide the securing clips upwards until they click, thereby securing the device to the DIN
rail.

4. Mount the external power unit in the same way.
4.3.2 Wall mounting
Mounting material (screws, dowels) are not included in the scope of delivery and must
be provided by the customer.
The external power unit can be mounted on a DIN rail only.
Use the back of the housing to mark the mounting holes.
1. Drill the corresponding holes and insert wall plugs if necessary.
2. Screw the housing onto the wall.
4.3.3 Mounting the optional external display
L
CAUTION
Sharp-edged, non-deburred drill holes
Risk of injury, display cable may get damaged!
‣
In particular, deburr the central drill hole for the display cable.