Endress+Hauser Liquiline CM44P - Page 20

Mounting Liquiline CM44P
20 Endress+Hauser
Mounting the display on the door of the cabinet
1. Hold the mounting plate from the outside against the door of the control cabinet.
Choose the point at which you wish to install the display.
2. Make all the markings.
.
.
.
. .
.
.
.
..
.
.
.
.
.
. .
.
.
.
..
.
.
4 x Ø 8 (0.31)
Ø 20 (0.79)
3. Draw lines to interconnect all the marks.
 This will indicate the position of the five drill holes needed.
4. Drill the holes (→  5,  14).