Liquiline CM44P Mounting
Endress+Hauser 21
5. Pull the display cable through the hole in the middle, and place the display from the
outside through the four holes drilled for this purpose, ensuring that the torx screws
have been unscrewed to the last half turn but are still in place. Ensure that the rubber
frame (seal, highlighted blue) does not become damaged and is properly positioned on
the surface of the door.
6. Connect the display cable to the RJ-45 socket in the base module.
7. Place the mounting plate on the inside over the screws (a), slide it down (b) and tighten
the screws (c).
The display is now mounted and ready to use.
To Next Page
Loading...
