Endress+Hauser Proline Promag W 400 - Page 43

Proline Promag W 400 Operation options
Endress+Hauser 43
8.2.1 Operational display
Status area
The following symbols appear in the status area of the operational display at the top right:
• Status signals
– F: Failure
– C: Function check
– S: Out of specification
– M: Maintenance required
• Diagnostic behavior
–
: Alarm
– : Warning
• : Locking (the device is locked via the hardware)
•
: Communication (communication via remote operation is active)
Display area
• Measured variables (depending on the device version), e.g.:
–
: Volume flow
– : Mass flow
– : Density
– G: Conductivity
–
: Temperature
• : Totalizer (the measurement channel number indicates which totalizer is displayed)
• : Output (the measurement channel number indicates which output is displayed)
• : Input
•
: Measurement channel number (if more than one channel is present for the same
measured variable type)
• Diagnostic behavior (for a diagnostic event that concerns the displayed measured variable)
– : Alarm
–
: Warning
8.2.2 Navigation view
Status area
The following appears in the status area of the navigation view in the top right corner:
• Of the submenu
– The direct access code for the parameter you are navigating to (e.g. 0022-1)
– If a diagnostic event is present, the diagnostic behavior and status signal
• In the wizard
If a diagnostic event is present, the diagnostic behavior and status signal