Proline Promag W 400 Diagnostic information
Endress+Hauser 61
Wizard/submenu Meaning
Output conditioning Define the output conditioning
Low flow cut off Set the low flow cut off
Empty pipe detection Configure empty pipe detection (EPD)
HART input Configure the HART input
10.6 Defining the tag name
To enable fast identification of the measuring point within the system, you can enter a unique
designation using the Device tag parameter and thus change the factory setting.
Navigation
"Setup" menu → Device tag
Parameter overview with brief description
Parameter Description User entry Factory setting
Device tag Enter the name for the
measuring point.
Max. 32 characters, such as
letters, numbers or special
characters (e.g. @, %, /).
Prowirl
10.7 Protecting settings from unauthorized access
The following options exist for protecting the configuration of the measuring device from
unintentional modification after commissioning:
• Write protection via access code for the local display and Web browser
• Write protection via write protection switch
• Write protection via keypad lock
For detailed information on protecting the settings against unauthorized access, see the
Operating Instructions for the device.
11 Diagnostic information
Faults detected by the self-monitoring system of the measuring device are displayed as a
diagnostic message in alternation with the operational display. The message on remedial
measures can be called up from the diagnostic messages, and contains important information
on the fault.
To Next Page
Loading...
