Endress+Hauser Proline t-mass 65I - Unit Corrected Volume Flow

3 Group SYSTEM UNITS Device Functions Proline t-mass 65
10 Endress+Hauser
UNIT CORRECTED VOL-
UME FLOW
Use this function to select the unit for displaying the corrected volume flow (corrected
volume/time).
The unit you select here is also valid for:
• Current outputs
• Frequency output
• Relay switch points (limit value for corrected volume flow, flow direction)
• Low flow cut off
! Note!
The following units of time can be selected:
s = second, m = minute, h = hour, d = day
Options:
Metric:
Normal liter
→ Nl/time unit
Normal cubic meter
→ Nm
3
/time unit
US:
Standard cubic meter
→ Sm
3
/time unit
Standard cubic foot
→ Scf/time unit
Factory setting:
Nm
3
/h or Sm
3
/h (country dependent, → Page 71 ff.)
UNIT CORRECTED
VOLUME
Use this function to select the unit for displaying the corrected volume.
The unit you select here is also valid for:
• Pulse value (e.g. Nm
3
/p)
Options:
Metric:
Nm
3
Nl
US:
Sm
3
Scf
Factory setting:
Nm
3
or Sm
3
(country dependent, → Page 71 ff.)
! Note!
The unit of the totalizers is independent of your choice here. The unit for each totalizer is
selected separately for the totalizer in question.
Function description SYSTEM UNITS