Mounting Prosonic S FMU90 Flow Measurement PROFIBUS
10 Endress+Hauser
L00-FMU90xxx-06-00-00-xx-006
1 Remote display of the FMU90 with adaption plate
2 Opening of the remote display of the FMU860/861/862
2.4 Mounting of the sensors
Information on the mounting of the sensors
2)
can be found in the following documents:
• Technical Information TI00189F (for FDU8x)
• Technical Information TI00396F (for FDU9x)
These documents are supplied with the sensors.
2.5 Installation check
After installing the device, carry out the following checks:
• Is the device damaged (visual inspection)?
• Does the device correspond to the measuring point specifications such as process
temperature, process pressure, ambient temperature, measuring range, etc.?
• If available: Are the measuring point number and labelling correct?
• Is the instrument sufficiently protected against rainfall and direct sunlight?
• For the field housing: Are the cable glands tightened correctly?
• Is the instrument securely mounted to the DIN rail or the mounting help (visual inspection)?
• For the field housing: Are the screws of the terminal compartment cover securely tightened
(visual inspection)?
2) The sensors FDU80/80F/81/81F/82/83/84/85/86/96 are not available anymore.
To Next Page
Loading...
