Endress+Hauser Prothermo NMT81 - Initial Setting; Initial Screen

Commissioning Prothermo NMT81
62 Endress+Hauser
Save / Restore
A0044921
 48 Save / Restore screen
Save: The information is sent to a PC from NMT81.
The information of writable parameters regarding device measurements can only be saved on
a PC.
Saving procedure
1. Press [Save / Restore].
2. Check upload from the device before saving in order to save the values that are actually
saved on the device.
3. Press [Save as].
4. Specify the saving destination.
5. Input a file name.
6. Press [Save].
 .deh file format is created.
This completes the saving procedure.
Restore: Information saved on a PC is sent to NMT81 again.
Restore procedure
1. Press [Save / Restore].
2. Check [Download data to device after loading].
 If data is restored without performing a check, the data is only updated in FieldCare
without sending to the master devices.
The data restore operation without check is used in offline work.
3. Press [Open].