Endress+Hauser RA33 - Page 11

RA33 Installation
Endress+Hauser 11
3. Screw the threaded rods (item 2) into the mounting plate (dimensions → å 3).
a0014173
Fig. 8: Preparing the mounting plate for panel mounting
4. Push the device into the panel cutout from the front and attach the mounting plate to the
device from the rear using the 4 screws provided (item 3).
5. Fasten the device in place by tightening the threaded rods.
a0014284
Fig. 9: Panel mounting