Installation RA33
6 Endress+Hauser
2.2 Scope of delivery
The scope of delivery of the batch controller comprises:
• Batch controller (field housing)
• Brief Operating Instructions in paper form, Operating Instructions and additional
documentation (on CD-ROM)
• Optional interface cable and DVD set with FieldCare Device Setup parameter configuration
software
• Optional Field Data Manager software
• Optional mounting hardware for top-hat rail, panel mounting, pipe mounting
• Optional overvoltage protection
!
Note!
Please note the device accessories in Section 8 ’Accessories’.
2.3 Certificates and approvals
CE mark, Declaration of Conformity
The device is safely built and tested according to state-of-the-art technology and has left the
factory in perfect condition as regards technical safety. The device meets the relevant standards
and directives as per EN 61 010 "Safety requirements for electrical equipment for measurement,
control and laboratory use".
Thus, the device described in these Operating Instructions meets the legal requirements of the
EU Directives. The manufacturer confirms successful testing of the device by affixing to it the
CE mark.
3 Installation
3.1 Incoming acceptance, transport and storage
The permitted environmental, storage and transportation conditions must be complied with. For
detailed specifications, refer to the "Technical data" chapter in the operating instructions.
3.1.1 Incoming acceptance
On receipt of the goods, check the following points:
• Are the packaging or contents damaged?
• Are the delivered goods complete? Compare the scope of delivery with your order
information.
3.1.2 Transport and storage
Observe the following points:
• Pack the device in such a way as to protect it reliably against impact for storage (and
transportation). The original packaging provides optimum protection.
To Next Page
Loading...
