RA33 Installation
Endress+Hauser 9
a0014610
Fig. 5: Dimensions of the top-hat rail adapter
3.3 Installation
The device with field housing and accessories is suitable for wall mount, pipe mounting, panel
mounting and top-hat rail installation.
The orientation is only determined by the legibility of the display. Connections and outputs are
fed out of the bottom of the device. The pipes are connected via coded clamps.
Operating temperature range:
-20 to 60 °C (-4 to 140 °F)
"
Caution!
To prevent heat build-up, do not expose the device to extreme heat or strong direct sunshine.
Operating the device in the upper temperature limit range decreases the operating life of the
display.
3.4 Installation
3.4.1 Wall mounting
1. Use the mounting plate as the template for drilled holes, dimensions → å 3
2. Attach the batch controller to the mounting plate and fasten it in place from the rear using
4 screws.
3. Fasten the mounting plate to the wall using 4 screws.
To Next Page
Loading...
