Endress+Hauser RIA15 - 4 Identification; Nameplate; Scope of Delivery; Certificates and Approvals

RIA15 Identification
Endress+Hauser 13
4 Identification
4.1 Nameplate
The nameplate is located on the right-hand side of the housing in the case of the field
device, and on the rear of the housing in the case of the panel-mounted device.
Ord. cd.: XXXXXXXX
Ser. no.: XXXXXXXXXXXXXXXXX
Ext. ord. cd.: RIA15-XXXXXXX
Ta= -40...+60°C
Front IP67 Type 4X Encl.
Loop powered 4...20 mA
RIA15 Made in Germany 2012
D-87484 Nesselwang
1
2
4
5
6
7
Class2 circuit or SELV circuit
3
9
8
A0019608
 3 Nameplate of the process display unit (example)
1 Order code of the device 6 Device designation
2 Serial number of the device 7 Approvals (optional)
3 Extended order code of the device 8 Input signal
4 Manufacturer's address 9 Housing degree of protection
5 Ambient temperature range
4.2 Scope of delivery
The scope of delivery of the device comprises:
• Panel-mounted device
– Process display unit
– Brief Operating Instructions
– Ex Safety Instructions (optional)
– Fastening fixtures
– HART® communication resistance module (optional)
• Field device
– Process display unit
– Brief Operating Instructions
– Ex Safety Instructions (optional)
– Fastening fixtures for wall/pipe mounting (optional)
– HART® communication resistance module (optional)
– Weather protection cover (optional)
4.3 Certificates and approvals
An overview of all available approvals is provided in the "Technical data" section.
→  54.
4.3.1 CE mark
The measuring system meets the legal requirements of the applicable EC guidelines. These
are listed in the corresponding EC Declaration of Conformity together with the standards
applied. Endress+Hauser confirms successful testing of the device by affixing to it the CE
mark.