Endress+Hauser RIA15 - Post-Installation Check

RIA15 Installation
Endress+Hauser 19
A0020785
 7
Mounting the optional HART
®
communication resistance module
1. Unplug the pluggable terminal block.
2.
Plug terminal block into the suitable plug-in position on the HART
®
communication
resistance module.
3.
Plug the HART
®
communication resistance module into the plug-in position on the
housing.
Field housing
The HART
®
communication resistance module is available as an accessory, see section
Accessories →  49.
A0020844
 8
Mounting the optional HART
®
communication resistance module
1. Unplug the pluggable terminal block.
2.
Plug terminal block into the suitable plug-in position on the HART
®
communication
resistance module.
3.
Plug the HART
®
communication resistance module into the plug-in position in the
housing.
5.4 Post-installation check
5.4.1 Display unit in the panel-mount housing
• Is the seal undamaged?
• Are the mounting clips securely fastened on the housing of the device?
• Are the threaded rods properly tightened?
• Is the device located in the center of the panel cutout?