Device description Turbimax CUS71D
14 Endress+Hauser
5.5 Calibration
5.5.1 Factory calibration
The sensor is precalibrated when leaving the factory. After adaption of the basin parameters, the
sensor can be used in a wide range of applications without additional calibration.
The factory calibration cannot be deleted and can be retrieved at any time. All other calibrations -
performed as customized calibrations - are referenced to this factory calibration.
5.5.2 Calibration in the process
Sensor calibration in the process is performed by inputs at Liquiline CM44x (see BA451C/07/EN).
5.6 Cyclic cleaning
For cyclic cleaning a ultrasonic sensor with integrated wiper is available. The time interval is
selectable via software.
To Next Page
Loading...
