Eneo EDMC-142 - Auto Scan Menu

57
3.3.1 Set Tours
Move cursor to TOUR: and set course number by .
Move cursor to
TITLE: and set proper title by and / .
Set dwell time by
(5~99 seconds) at DWELL TIME:
Move cursor to
- - and select proper preset number by .
Each point can be inserted progressively.
3.3.2 Run Tour
Tour function is that you can watch preset points orderly. In order to run tour
function, press course number key and press TOUR key.
For example, you want to run tour course 2, press
2 key and press TOUR key.
If you are in menu mode, this is invalid.
3.4 Auto Scan Menu
AUTO SCAN MENU
SCAN: 1
TITLE:
START POINT: 000.00
TILT AND ZOOM: 000.00
END POINT: 000.00
SAVE AND EXIT
EXIT