/ : move cursor up and down
/ : move cursor left and right or select or change values
: change the character at TITLE
/ ESC : exit current menu without data saving
3.4.1 Set Auto Scans
Move cursor to SCAN: and set course number by / .
Move cursor to
TITLE: and set proper title by and / .
Move cursor to
START POINT: and set start point by joystick control with pressing
CTRL key.
Do not release
CTRL key until the camera’s zooming, panning and tilting motion has
been completed.
If IRIS CLOSE is pressed too soon, improper data will be saved.
TILT AND ZOOM: and END POINT: can be set as same as above setting methods.
3.4.2 Run Auto Scan
The method is similar as the tour’s. Press number and press SCAN key.
For example, you want to run auto scan course 4, press
4 key and press SCAN key.
If you are in menu mode, this is invalid.
To Next Page
Loading...
