Understanding The Function Key ‘MENU’, ‘SET’ And ‘SEL’ During
Charger Setting
CH1 - display is showing the charging battery
info (charging status, voltage and current).
CH2 or CH3 - When displayed solid means the
power is getting from the related channel and
the other channel will be ashing if it is available
but not charging.
“V“ - Display is showing the voltage
“A“ - display is showing the current
“Auto“ - unit Silent mode is on
“Priority“ - unit alternator terminal is High or
unit is set to Manual Override mode
“Mode“ - charging mode setting*
“Temp“ - Temperature setting*
*Will only display when selected setting is active
Digital Display:
•
During the charging process, the display shows ‘CH1’ charging status, voltage and current
repeatedly, and ‘CH2’ or ‘CH3’ is solid to indicate the recent active input source. If the other
input channel is available and the voltage is above the ‘CH2 and CH3 Flashing Voltage’
the icon will be ashing. When ‘MENU’ is pressed once, the display will change to show
CH2 voltage for 3 seconds and CH3 voltage for 3 seconds. The display will then go back to
normal automatically and will show the CH1 info.
•
When the Battery (CH1) is fully charged, it will show ‘CH1’ and ‘FLO’, voltage and current
repeatedly on the display and both CH2 and CH3 icons will be ashing if the two channels
are within voltage range. This indicates the DC input source is available.
•
The selected battery type icon is always ON at all times during the whole charging process.
•
‘Priority’ Icon turns ON when the alternator terminal is connected to high or the unit is set
to ‘Manual Override’ mode.
To Next Page
Loading...
