EnerSys alpha Matrix C16 - Network Cable Installation; Ethernet Cable Connection

To Next Page

To Previous Page

C048-725-30 Rev. B (01/2020)

4.9 4.9 Installing the Network CableInstalling the Network Cable

If remote monitoring over the network is required, complete

the following steps to connect the Ethernet module with

embedded web server�

NOTE: For initial conguration, it is recommended to use a

crossover Cat 5/5e/6 UTP cable to connect a laptop directly to

the Ethernet port of the Matrix panel. If the laptop is congured

for Auto MDI-X, a straight-through cable may be used�

Step 1. Connect a Cat 5/5e/6 UTP Ethernet cable from the local

network to the Ethernet port on the rear of the panel�

Refer to "Appendix A: Mechanical Drawings" on Page

27 for exact location� Use a TIA/EIA T-568B pinout for

the network connection�

Step 2. For information on conguring the web server, see "5.6

Review System Status via the Embedded Web server"

on Page 18�

Figure 16. Ethernet Jack