enphase IQ System Controller 3 INT User Manual

4
IQ System Controller 3 INT Quick Install Guide
Tools/additional items required
S. NO ITEM NAME MINIMUM QUANTITY SOURCE
1 Breakers of dierent ratings 4 Provided by installer
2 Conduits (with ttings and tting tools) - IP55 and above (for non-rear entry systems) As required Provided by installer
3 IP55 conduit ground locknut (for non-rear entry systems) 1 Provided by installer
4 M6 pilot bit 1 Provided by installer
5 Screw driver 1 Provided by installer
6 Wrench 1 Provided by installer
7 Adjustable wrench 1 Provided by installer
8 Torque wrench up to 10 N m 1 Provided by installer
9 Level 1 Provided by installer
10 5/32" Allen key 2 Provided by installer
11 Conductor stripper 1 Provided by installer
12 Electrician’s hole saw (2") or punch set 1 pair Provided by installer
13 Stud nder 1 Provided by installer
14 Drill, drill bit extender As required Provided by installer
15
M6 lag bolts or screw 80 mm long (depending on attaching wall) for each wall-mount
bracket
2 Provided by installer
16 Control wire As required Provided by installer*
Section A
Mounting an
IQ System Controller 3 INT
NOTE: The IQ System Controller 3 INT weighs 15.2 kg and will
require two people to lift and align the unit.
* Recommended Electra EAS7302PHV or the LAPP 1270802

enphase IQ System Controller 3 INT Specifications

General

Brand	enphase
Model	IQ System Controller 3 INT
Category	Controller
Language	English