IQ7/IQ7+/IQ7X/IQ7A Microinverters Installation and Operation Manual
34 © 2023 Enphase Energy Inc. All rights reserved. September 2023
IOM-00028-1.0
Enphase IQ7-60-2-US Microinverter parameters
Topic Unit Min Typical Max
Cooling Natural convection - no fans
Relative humidity range 4% to 100% condensing
Approved for wet locations Yes
Pollution degree PD3
Standard warranty term enphase.com/warranty
Compliance CA Rule 21 (UL 1741-SA) UL 62109-1, UL1741/IEEE1547, FCC
Part 15 Class B, ICES-0003 Class B, CAN/CSA-C22.2 NO.
107.1-01
This product is UL Listed as PV Rapid Shut Down Equipment
and conforms with NEC-2014 and NEC-2017 section 690.12
and C22.1-2015 Rule 64-218 Rapid Shutdown of PV Systems
for AC and DC conductors when installed according to
manufacturer’s instructions.
Grounding
The DC circuit meets the requirements for ungrounded PV
arrays in NEC. Ground fault protection (GFP) is integrated
into the class II double-insulated microinverter.
Monitoring
Enphase Installer Portal monitoring options require an
Enphase IQ Gateway.
Communication Power line communication (PLC)
Integrated DC disconnect/
Integrated AC disconnect
The DC and AC connectors have been evaluated and
approved for use as the load-break disconnect required by
NEC 690.
To Next Page
Loading...
