Enterasys C2RPS-SYS - Chapter 2: Installation; Unpacking Chassis and Power Supply Module(s)

SecureStack C2 Installation Guide 2-1
2
Installation
ThischapterprovidestheinstallationinstructionstoinstallallthecomponentsofanRPS.
TocorrectlyinstallanRPS,followtheorderofinformationlistedbelow.
Required Tools
Aflat‐bladescrewdriverisrequiredtoinstalltheC2RPS‐CHAS8andC2RPS‐PSMs.
Unpacking Chassis and Power Supply Module(s)
TheC2RPS‐CHAS8andC2RPS‐PSMareshippedseparately.Tounpackthesedevices
proceedasfollows:
1. Opentheboxandremovethe packingmaterialprotectingthedevices.
2. Verifythecontentsofeachcartonandcomparethecontentsshippedwiththoselisted
inTable 2‐1andTable 2‐2.
Electrical Hazard: Only qualified personnel should perform installation procedures.
Advertencia eléctrica: Solamente personal calificado debe realizar procedimientos de
instalacion.
Elektrischer Gefahrenhinweis: Installationen sollten nur durch ausgebildetes und
qualifiziertes Personal vorgenommen werden.
For information about... Refer to page...
Required Tools 2-1
Unpacking Chassis and Power Supply Module(s) 2-1
Installing C2RPS-PSMs 2-2
Installing C2RPS-CHAS8 into the Rack 2-4
Connecting the PSM Cables and AC Power Cords 2-6