Enterasys C2RPS-SYS - Installing C2 RPS-PSMs

Installing C2RPS-PSMs
2-2 Installation
3. Performavisualinspectionoftheswitchdevicesforanysignsofphysicaldamage.
ContactEnterasysNetworksifthereareanysignsofdamage.Referto“GettingHelp”
onpage 1‐5fordetails.
Installing C2RPS-PSMs
WhenyoureceiveyourC2RPS‐CHAS8chassis,acoverplatewillbeinplaceovereach
power‐supplyslot.
ToinstallthePSMs,refertoFigure 2‐1andproceedasfollows:
1. Placethechassisonasturdyflatsurfaceandremovethecoverplatesfromtheslots
whereyouplantoinstallPSM
s.
2. AlignthePSMwithoneoftheslots,thenslidethePSMforwarduntilitsfrontpanelis
flushagainstthechassisfrontpanel.
3. FastenthePSMtothechassisusingthecaptivescrews.
4. Repeatsteps2and3foreachadditionalPSM.
Table 2-1 Contents of C2RPS-CHAS8 Carton
Item Quantity
C2RPS-CHAS8 1
SecureStack C2 Redundant Power System Installation Guide (9033977-xx) 1
Release Notes 1
Table 2-2 Contents of C2RPS-PSM Carton
Item Quantity
C2RPS-PSM 150 Watt DC Power Supply Module 1
USA, NEMA Power Cord 1
C2RPS-PSM Cable 1
Notice Card 1
Caution: Observe all Electrostatic Discharge (ESD) precautions when handling sensitive
electronic equipment.
Precaución: Al trabajar con equipos electrónicos sensibles, tome todas las
precaucionesde seguridad para evitar descargas de electricidad estática.
Note: To prevent EMI leakage from the chassis, keep coverplates installed over any empty
power supply slots.