Enterasys Wireless AP3710/AP3725 Installation Guide 1-1
1
Introduction
This installation guide provides an overview and installation instructions for the Enterasys
Wireless Access Points WS-AP3710 and WS-AP3725.
About the WS-AP3710 and WS-AP3725
The WS-AP3710 and WS-AP3725 access points are a cost-effective solution for extending your
wireless LAN around indoor locations. They interoperate fully with the Enterasys wireless LAN,
including support for Enterasys wireless VoWLAN, branch office mode, availability and mobility
features.
The WS-AP3710 and WS-AP3725 are nearly identical in appearance and have the following
features in common:
• Both operate in 802.11n mode, and also support 802.11a/802.11g and 802.11b standard legacy
devices.
• Both support two MIMO 3x3 (up to three 802.11n spatial streams).
• They provide two single band radios for dual-band, concurrent operation, optimized for
indoor antenna coverage:
– 5GHz (Radio 1) in any of the following modes: IEEE802.11 a/b/g and/or n
– 2.4GHz (Radio 2) in any of the following modes: IEEE802.11 a/b/g and/or n
• They are enclosed in a rectangular, compact case.
• Both come in “i” (internal antenna) and “e” (external antenna) models.
• Both models include a mounting bracket for mounting them to walls and drop ceilings. (For
mounting on drop ceilings, an optional T-bar rail clamp accessory is needed.)
• They provide 40MHz Bandwidth at 2.4/5GHz operation (Channel Bonding).
• They can be powered directly through the LAN using Power over Ethernet (PoE), or by an
external 120/240V AC/DC adaptor.
The Enterasys Wireless WS-AP3710 and WS-AP3725 APs are the mid-range and high-end models
(respectively) of the Enterasys Wireless AP37xx product family, along with the entry-level
For information about... Refer to page...
About the WS-AP3710 and WS-AP3725 1-1
WS-AP3710 Overview 1-2
WS-AP3725 Overview 1-7
Common Architectural Features 1-11
To Next Page
Loading...
Need help?
General
