Enterasys Wireless WS-AP3710 and WS-AP3725
B-4
• Translation needed here — (Under Industry Canada regulations, this radio transmitter may
only operate using an antenna of a type and maximum (or lesser) gain approved for the
transmitter by Industry Canada. To reduce potential radio interference to other users, the
antenna type and its gain should be so chosen that the equivalent isotropically radiated power
(e.i.r.p.) is not more than that necessary for successful communication.)
Canada Conformance Standards
This equipment meets the following conformance standards:
Safety
• C22.2 No.60950-1-03
EMC
• ICES-003, Class B
Radio transceiver
• RSS-210 (2.4 GHz and 5GHz)
Other
• IEEE 802.11a (5 GHz)
• IEEE 802.11b/g (2.4 GHz)
• IEEE 802.11n
• IEEE 802.3af (PoE)
RF Safety Distance
The antennas used for this transmitter must be installed to provide a separation distance of at least
20 cm from all persons and must not be co-located or operating in conjunction with another
antenna or transmitter.
French translation needed here
European Community
The Enterasys Wireless AP3710/AP3725 is designed for use in the European Union and other
countries with similar regulatory restrictions where the end user or installer is allowed to
configure the Enterasys Wireless AP3710/AP3725 for operation by entry of a country code relative
to a specific country. After the country code is selected, the Enterasys Wireless AP3710/AP3725
uses the proper frequencies and power outputs for that country code.
The Enterasys Wireless AP3710/AP3725 is intended for indoor use and must be installed in a
proper indoor location. Contact local Authority for procedure to follow and regulatory
information. For more details on legal combinations of frequencies, power levels and antennas,
contact Enterasys.
Declaration of Conformity with R&TTE Directive of the European Union 1999/5/EC
The following symbol indicates compliance with the Essential Requirements of the R&TTE
Directive of the European Union (1999/5/EC).
To Next Page
Loading...
Need help?
General
