Enterasys Wireless WS-AP3710 and WS-AP3725
Enterasys Wireless AP3710/AP3725 Installation Guide B-7
• IEEE 802.11b/g (2.4 GHz)
• IEEE 802.11n
• IEEE 802.3af (PoE)
RoHS
• European Directive 2002/95/EC
Conditions of use in the European Community
Some EU countries allow outdoor operation with limitations and restrictions, which are described
in this section. It is the responsibility of the end user to ensure operation in accordance with these
rules, frequencies, and transmitter power output. The Enterasys Wireless AP3710/AP3725 must
not be operated until configured for the customer’s geographic location.
European Spectrum Usage Rules
The AP configured with approved internal antennas can be used for indoor transmissions
throughout the European community as displayed in Table B-1. Some restrictions apply in France,
Greece, and Italy.
Caution: The user or installer is responsible to ensure that the Enterasys Wireless AP3710/AP3725
is operated according to channel limitations, indoor / outdoor restrictions, license requirements, and
within power level limits for the current country of operation. A configuration utility has been
provided with the Wireless AP to allow the end user to check the configuration and make necessary
configuration changes to ensure proper operation in accordance with the spectrum usage rules for
compliance with the European R&TTE directive 1999/5/EC.
Caution: Please follow the instructions in this user guide to configure the Enterasys Wireless
AP3710/AP3725.
• Each Wireless AP is configured with a default group of settings. There is the ability to change
these settings. The user or installer is responsible to ensure that each Enterasys Wireless
AP3710/AP3725 is configured properly.
• The software within the Wireless AP automatically limits the allowable channels and output
power determined by the selected country code. Selecting the incorrect country of operation or
misidentifying the antenna being used,may result in illegal operation and may cause harmful
interference to other systems.
• This device employs a radar detection feature required for European Community operation in the
5 GHz band. This feature is automatically enabled when the country of operation is correctly
configured for any European Community country. The presence of nearby radar operation may
result in temporary interruption of operation of this device. The radar detection feature will
automatically restart operation on a channel free of radar.
• The 5150- 5350 MHz band, channels 36, 40, 44, 48, 52, 56, 60, or 64, are restricted to indoor
use only.
• The 2.4 GHz band, channels 1 - 13, may be used for indoor use but there may be some channel
restrictions.
• In France, outdoor operation is not permitted using the 2.4 - 2.454 GHz band.
Table B-1 European Spectrum Usage Rules
Country
5.15-5.25 (GHz)
Channels:
36,40,44,48
5.25-5.35 (GHz)
Channels:
52,56,60,64
5.47-5.725 (GHz)
Channels:
100,104,108,112,116,
132,136,140
2.4-2.4835 (GHz)
Channels: 1 to 13
(Except Where Noted)
Austria Indoor only Indoor only Indoor or outdoor Indoor or outdoor
To Next Page
Loading...
Need help?
General
