Enterasys Wireless WS-AP3710 and WS-AP3725
B-2
interference, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the transmitting antenna.
• Increase the separation between the equipment or devices.
• Connect the equipment to an outlet other than the receiver's.
• Consult a dealer or an experienced radio/TV technician for suggestions.
USA Conformance Standards
This equipment meets the following conformance standards:
Safety
• UL 60950-1
EMC
• FCC CFR 47 Part 15, Class B
Radio transceiver
• CFR 47 Part 15.247, Subpart C
• CFR 47 Part 15.407, Subpart E
Other
• IEEE 802.11a (5 GHz)
• IEEE 802.11b/g (2.4 GHz)
• IEEE 802.11n
• IEEE 802.3af (PoE)
FCC RF Radiation Exposure Statement
The Enterasys Wireless AP3710/AP3725 complies with FCC RF radiated exposure limits set forth
for an uncontrolled environment. End users must follow the specific operating instructions for
satisfying RF exposure compliance. This device has been tested and has demonstrated compliance
when simultaneously operated in the 2.4 GHz and 5 GHz frequency ranges. This device must not
be co-located or operated in conjunction with any other antenna or transmitter.
The radiated output power of the Enterasys Wireless AP3710/AP3725 is below the FCC radio
frequency exposure limits as specified in “Guidelines for Human Exposure to Radio Frequency
Electromagnetic Fields” (OET Bulletin 65, Supplement C). This equipment should be installed and
Warning: The Enterasys Wireless AP3710/AP3725 must be installed and used in strict accordance
with the manufacturer's instructions as described in this guide and related documentation for the
device to which the Enterasys Wireless AP3710/AP3725 is connected. Any other installation or use
of the product violates FCC Part 15 regulations.
This Part 15 radio device operates on a non-interference basis with other devices operating at the
same frequency when using the antennas provided or other Enterasys-certified antennas. Any
changes or modifications to the product not expressly approved by Enterasys could void the user's
authority to operate this device.
For the product available in the USA market, only channels 1 to 11 can be operated. Selection of
other channels in the 2.4 GHz band is not possible.
To Next Page
Loading...
Need help?
General
