MAINTENANCE
Blanket Warmer ▪ Operat or’s Manu a l ▪ MN -4 6 42 7 ▪ Rev 1 ▪ 6/19
33
MAINTENANCE
Maintenance Schedule
Daily For daily maintenance, do the following.
Check:
▪ the air vents in the airflow insert panels are not obstructed (if applicable).
▪ all fan guards are clear and not obstructed (if applicable).
▪ the number of bottles/bags, or blankets as applicable do not exceed the
maximum capacity per shelf or basket.
Clean:
▪ any spills with a clean, lint free cloth.
Monthly For monthly maintenance, do the following.
Check:
▪ the door gasket for tears and holes. Make sure that it is firmly attached to the
door. Check the seal when the door is closed.
▪ the guards around the air temperature sensor are in place and fully secure to the
warmer.
▪ the hardware securing the warmer(s) to the wall, if applicable.
Clean:
▪ the outside of the warmer with stainless steel cleaner.
▪ vacuum (if applicable):
□ fan openings
□ fan sail switch
□ vent openings
Yearly For yearly maintenance, do the following.
Check:
▪ the set-point temperature compared to the actual temperature displayed.
□ Check the cavity air temperature with a thermocouple placed 1” (25mm) from
the cavity sensor. Do not allow the thermocouple to touch any surface.
Monitor the temperature for approximately one hour in an empty cavity.
▪ the condition of the plug and cord and replace if damaged.
▪ the controller screen for excessive wear. Make sure the controller screen displays
and operates properly.
Clean:
▪ the shelves and interior of the warmer.
To Next Page
Loading...
