Safety
Electrical safety
◼ This device must be operated in accordance with applicable national and local electrical and
construction codes.
◼ This device can be damaged by excess voltage outside the operating range defined within this
products datasheet.
◼ To reduce the risk of fire or electrical faults do not exceed the ratings and limitations defined in
the product datasheet or this guide.
◼ Ensure there are no opportunities for cables to short circuit and cabling cannot be snagged or
pulled.
◼ Do not over stretch cabling to the device’s connectors and ensure that cabling does not exert
force on the PCB.
◼ Isolate your installation from power immediately if accessories power cables or connectors is in
any way damaged, defective, shows signs of overheating or are wet.
◼ Remove power from this product during cleaning or when it is not in use.
◼ Do not connect this device to a dimmer pack or mains electricity.
◼ Do not connect any of this device’s 0V, V- or GND connectors to earth.
◼ Ensure your installation is protected from short circuits and overcurrent.
◼ Ensure all connections are complete and secure before providing power to the device.
System Planning and Specification
◼ To contribute to an optimal operating temperature, where possible keep this device out of direct
sunlight.
◼ This unit has an IP20 rating and is not designed to be exposed to moisture or condensing
humidity.
◼ Ensure this device is only operated within the specified ranges within the product datasheet.
Protection from Injury During Installation
◼ Always use suitable personal protective equipment when installing ENTTEC products.
◼ Once installation is completed, check that all hardware and components are securely in place
and fastened to supporting structures if applicable.
Installation Safety Guidelines
◼ This device is convection cooled, ensure it receives sufficient airflow so heat can be dissipated.
◼ Do not cover the device with insulating material of any kind.
◼ Do not operate the device if the ambient temperature exceeds that stated in the device
specifications.
◼ Do not cover or enclose the device without a suitable and proven method of dissipating heat.
◼ Do not install the device in damp or wet environments.
◼ Do not modify the device hardware in any way.
◼ Do not use the device if you see any signs of damage.
◼ Do not handle the device in an energized state.
◼ Do not crush the device during installation.
◼ Do not sign off a system without ensuring all cabling to the device and accessories has been
appropriately restrained, secured and is not under tension.
To Next Page
Loading...
