Envirotainer RKN e1 - Setting Temperature (Type 2)

Operations Manual
7. CONTROL UNIT OPERATION — TYPE 1 AND
TYPE 2
Envirotainer RKN e1 Container
7.2.2 SETTING TEMPERATURE
The recommended procedure is:
1. To change between Celsius and Fahrenheit:
• Press to enter the main menu; the display shows ”TEMP MENU“.
• Press to enter the ”TEMP MENU“; the display shows ”SET TEMP“.
• Use or to step to ”Current unit F Set changes to C“ or
”Current unit C Set changes to F“(depending on current setting).
• Press to confirm the change.
• Press to return to default mode.
2. Press to enter the main menu; the display shows ”TEMP MENU“.
3. Press to enter the ”TEMP MENU“; the display shows ”SET TEMP“.
4. Press to enter the ”SET TEMP“; the display shows ”SET NEW TEMP“.
IMPORTANT
The ”SET NEW TEMP“ mode is activated for 30 seconds. If the display returns to default mode
before new set temperature has been confirmed by pressing , the new container set temperature
was not saved.
5. Use and to change the container set temperature.
Hold down the buttons to speed up the change.
6. Press to confirm the new container set temperature.
7. Press to return to default mode.
8. Check that the container set temperature is correct in the default mode.
7.2.3 CHECKING OPERATION MODE
The recommended procedure is:
1. Press to enter the main menu; the display shows ”TEMP MENU“.
2. Use or button to step to ”SYSTEM MENU“ and press to confirm; the display
shows ”ALARM VIEW“.
3. Use or button to step to ”OPER. MODE“ and press to confirm.
4. Check current operation mode.
Refer to chapter 8. Operation Modes, Infos, Alerts And Alarms.
5. Press twice to return to default mode.
Doc No. MO-RKN-3009
Version 2.2: 2017-08-31 24 (42)